3Com 3C421600A Reference Manual page 156

156 C 4: R
HAPTER OUTER
C R
OMMAND EFERENCE
connection_type
dial_prefix
filter_access
host_address
host_type
init_script
input_filter
login_service
Sets connection type for switched interface. Options:
Direct_net — Uses the protocol parameter setting to create
a network (virtual node) connection. Employs username
and password specified in this command. Authentication is
done by the network protocol such as PPP. Direct_net does
not support the SLIP protocol.
Direct_conn — Employs username and password specified
in this command to establish a login type connection to the
target host. Authentication is accomplished by the target
host. If username and password are not specified with this
choice, user "default" is employed.
Normal — Prompts for both username and password.
Default.
Prompt_user_only — Prompts for username only and
authenticate with the password specified in this command.
No_prompt — Does not prompt. Authenticates with the
username and password specified in this command. If
username and password are not specified with this choice,
user "default" is employed.
Prefix added to all phone numbers dialing from this port. Limit:
7 characters.
Turns filtering ON or OFF. Default: Off.
IP address to connect a dial-in user to, if the host type is
specified, and connection_type is direct_conn or direct_net.
Identifies how connection is established. Dial-in user is the
following:
Prompt — Prompted to enter a host name or address.
Select — Connected to a login host, selected from the list
of login hosts, determined by the host_select field in the
set connection command. Default.
Specified — Connected to the configured IP address.
Name of modem initialization script used. Maximum size: 7
ASCII characters. If you are setting an init_script for a Modem
Pool or Interface the init_script name must already exist. A null
string ("") indicates the name is deleted. Default: USR_int
File name of filter screening incoming data.
Login service to use if the connection_type is not direct_net.
Options:
Telnet. Default.
RLOGIN.
ClearTCP.
Ping — User pings a login host, receives a successful/
unsuccessful message and is disconnected.