list ipx static routes
list lan interfaces
list login_hosts
Displays all IPX static routes previously defined using the add ipx
route command. It lists the following:
Network address(es) — Network address requiring this route.
NextHopNIC — Network address of the next router in the routing
path.
Gateway — Address of the host you defined as the gateway.
Metric — Number of routers a packet must pass through to get to
gateway.
Ticks — Delay, in hops, to reach the route destination.
Displays installed interfaces — Ethernet (rm0/eth:1), its operational
status, administration status, and interface index. If the interface is
DOWN under Admin Status, you can use enable interface to try to bring it
up. The command lists the following:
Name — LAN interface name: rm0/eth:1.
Oper Status — Current operating status of the interface: Up or Down.
Admin Status — Permanently configured status of the interface, Up or
Down.
Displays currently defined entries in the Login Host Table that you
previously defined using add login_host. Values displayed are the
following:
Preference — Preference (priority) number assigned to the host.
Name — Name you assigned the login host.
Port — Rlogin, Telnet, and ClearTCP TCP port numbers assigned to
that login host.
Host Address — Address assigned to the login host.
List Commands
109