Show Ip Security Or Show Ip Security Settings; Show Ip Udp_Broadcast_ Forwarding; Show Ipx Or Show Ipx Settings - 3Com 3C421600A Reference Manual

194 C 4: R
HAPTER OUTER
show ip security or
show ip security
settings
show ip
udp_broadcast_
forwarding
show ipx or show ipx
settings
C R
OMMAND EFERENCE
IP RIP Flags — Type of IP RIP flags enabled.
IP ROUTER SETTING
IP Router Administrative Status
IP Static Remote Routes
IP LAN Host address:
IP Autonomous System Number
IP Max Table Size:
IP Max Metric Entries:
IP RIP:
IP Number RIP Interfaces:
IP Number RIP Neighbors:
IP RIP Flags:
Displays state (enabled or disabled) of IP security settings. The settings
shown below are defaults. See the enable ip security_options
commands for more information.
IP SECURITY SETTINGS
Drop All Fragoffset1:
Drop TCP Fragoffset1
Disallow All Header Options
Disallow Source Route Options: DISABLED
Displays state (enabled or disabled) of IP upd_broadcast_forwarding. The
default for udp_broadcast forwarding is "disabled."
Displays settings for dynamic IPX networks. You can modify these values
using the set ipx system command. It lists the following:
Default Gateway — Default IPX router address.
Name — Designation for dynamic IPX networks.
Network Number — Network number for dynamic IPX networks.
Max Open Sockets — Maximum allowed number of open sockets to
remote IPX networks.
Max Hops — Maximum allowed hops to remote IPX networks.
Priority — Preferred ranking of dynamic IPX networks.
Enabled
Enabled
165.134.145.124
1
1450
512
Enabled
0
0
METRICS
SEND_REQUEST
ENABLED
ENABLED
DISABLED