94
C
4: R
HAPTER
OUTER
Exit Command
exit
Hangup Commands
hangup interface
<interface_name>
C
R
OMMAND
EFERENCE
enabled is the default. You can use list users to see which users are
currently disabled.
Leave the CLI, but keep this connection open. This command returns you
to Dial-In user or Telnet commands.
Cuts interface or modem group connections.
Disconnects any calls (causes the connection on the specified interface to
hangup and leave the interface(s) in an Enabled state.
You can use this command on multiple interfaces in one command. The
following is the format of the list:
hangup interface <interface 1>,<interface 2>,...
The following is the format of each modem interface:
x/slot:y/mod:z
where x is the type of unit (rm0 for the RAS 1500 unit, pem0 or pem1 for
the RAS 1500 Expansion Unit), y is the slot number, and z is the modem
number.
Example:
rm0/slot:1/mod:1,pem0/slot:1/mod:2
Enter interfaces from the same slot in ranges.
Example:
rm0/slot:1/mod:[1-4],pem0/slot:1/mod:[1-4]
Example:
hangup interface rm0/slot:1/mod:[1-4],pem0/slot:1/mod:1