Connecting to a Novell (IPX) Network
To connect to a Novell network using FastConnect,
enter
at the command prompt on the Quick
NO
Configuration screen to display the screen illustrated
in
Figure
1-11.
Figure 1-11 Connecting To A Novell Network
Complete the fields on this screen as follows:
Quick Configuration
Do you have a local server? Use the [Spacebar] to
toggle this field to Yes or No as appropriate.
If you have a local server, the unit's configuration is
updated to ensure that no data destined for local
servers is passed over the link
Remote ISDN Number Type the ISDN number of the
remote unit that connects to the Novell network.
Call Type Set the Call Type for each ISDN number.
Use 64k Unrestricted for Euro ISDN lines. Use 56k V.110
or 56k_restricted in the USA depending on the
requirements of your ISDN service provider.
Press [CTRL]+[E] to submit this information.
When you do this the unit automatically makes a
short call to the remote unit to interrogate the
remote network for information about its servers.
When it has obtained the information it needs the
call is automatically disconnected. The unit then
updates the autocall table so that when data is
destined for a remote server, the unit automatically
dials the correct ISDN number and connects to the
remote network.
Enter
at the command prompt to permanently
SAVE
store this configuration in the unit's memory.
1-23