Control Operation At Regular Intervals [I/D Unit Cyclic] - Panasonic CZ-256ESMC3 Operating Instructions Manual

Control operation at regular intervals
This type of control rotates through the set times slots at the specified intervals (3 minutes, 4 minutes,
5 minutes), evenly operating the indoor units in the control groups using the settings (OFF, thermostat,
mode, set temperature) and recovering.
Attention
y Register the demand point input before making these settings. (P.89)
y Before making these settings, also cancel the demand operation settings ([No settings]) for the outdoor units in the "O/D unit information"
screen. (P.35)
When using cycling control at 5 minute intervals on the indoor
units in control groups 1 to 5
Control groups 1 to 3 are "T/S OFF" and control groups 4 and 5 are
"Fan", and if the interval is "5 min.", the cycling control happens at
5 minute intervals.
1
Touch [Demand setting] in
"EnergySaving".
2
Touch [I/D unit cyclic].
Enter the identification number (password level 1 or 2) and
z
the "I/D unit cyclic" screen is displayed.
3
1
4
2
98
5 min. 5 min.
Thermostat
Control group 1
forced OFF
Normal Thermostat
Control group 2
operation forced OFF
Control group 3
Normal operation
Control group 4
Normal operation
Control group 5
Normal operation
Put a check mark in the "Select" column
(3-1), and touch [Set.] (3-2).
The "Setting" dialogue is displayed.
z
3-
1
3-
Change the settings.
Item
Control Gr. 1-10
Press
the indoor unit is to be allocated to. (Up to
10 groups)
Set from "Gr.1" to "Gr.10".
Ope. Operation of the indoor units is stopped.
Set either [OFF] or [----]*.
T/S The thermostat is set to off forcibly.
Select between [T/S OFF] and [----]*.
[I/D unit cyclic]
5 min. 5 min. 5 min.
Normal operation
Normal operation
Thermostat
Normal operation
forced OFF
Normal
Fan
operation
Fan
2
Explanation
to set the control group that
Continued on next page