Panasonic CZ-256ESMC3 Operating Instructions Manual page 73

4
Set the time slots to display.
(1) Touch [Time] (4-1).
The "Specify time" dialogue is displayed.
z
(2) Touch the time slot to accumulate (4-2).
Refer to "RglrHourRnge" in "Calendr sttgs for distr calc"
z
(P.148) for information about "Rglr hour1" to "Rglr hour8".
The settings are registered and the "Specify time" dialogue
z
closes.
Note
y The calculations for distribution made by this unit do not accord with the relevant laws and statutes, so they cannot be used for official
transactions.
y The operating time data accumulated on the indoor units is acquired via a communication adaptor. When this unit sends a request for the
data to the communication adaptor, the communication adaptor makes inquiries to the indoor units about their operating hours, and when
collection is complete is transfers the results to this unit. This may result in a difference in counts when moving from one time slot to the next.
y Stopping of indoor units by scheduling is subject to some delays due to communications, so make sure it is not set at the same time as the
"RglrHourRnge stngs" (P.150) time slot is changed over. If the schedule stops operation prior to the change over of a time slot, avoid setting it
inside 10 minutes (this may change depending on the state of communications) of the change over of the time slot.
y When there is a problem with the communications between the main unit and the indoor units (or the communication adaptor), it may not
be possible to accumulate by time slot normally. The accumulated values received by this unit are counted in the time slot when they are
received.
y The usage in [All hours] in the "Specify time" dialogue is calculated from the distribution ratio distributed overall according to the total
operating data from all time slots. This means that the usages in [RglHour], [OutOf hour], and [SpcfiedDay] will not match.
y If you remove an air conditioning unit after accumulating distribution data, all accumulated values for that air conditioning unit are deleted, so
it will not be possible to view distribution data that includes that air conditioning unit after it is removed.
Before removing the unit, output (save) the distribution data as a CSV file to a USB memory device.
The output method for CSV files is the same as for outputting logs. (→ "Outputting (saving) the displayed contents as a CSV file" (P.32))
5
4-
1
4-
2
73
Checking distribution data in a list
Checking distribution data.