What is a "setting cell"?
To set a schedule, you need to register operations in "setting cells". The "setting cell" is the smallest unit of operations used to
configure a schedule.
You set "Time", "ON/OFF", "OpertnMode", "Temperatre", "Fan SPD", "Flap", "Prhbt", and "EnerSavStg" in a "setting cell". Each
time you change an operation (for example from "ON" to "OFF"), you register a different "setting cell".
A schedule consists of a collection of these "setting cells" lined up.
The following is an example schedule set for an indoor unit.
Example
The following summarises the flow followed when setting a schedule.
(1) Select the daily running mode to register for a schedule.
↓
(2) Select an indoor unit or schedule group.
↓
(3) Set the schedule.
↓
(4) Register the setting.
In the "09:00" setting cell
y "Time":
09:00
y "ON/OFF":
ON
y "OpertnMode":
Cool
y "Temperatre":
28 °C
y "Fan SPD":
Low
y "Flap":
Swing
42
Setting cell (this example shows "Time" displayed)
1 block equates to a setting cell, so here
there are 7 settings.
Example
In the "09:15" setting cell
y "Time":
09:15
y "ON/OFF":
ON (no change to the setting)
y "OpertnMode":
Dry
y "Temperatre":
28 °C (no change to the setting)
y "Fan SPD":
Low (no change to the setting)
y "Flap":
Swing (no change to the setting)
Schedule setting flow