Energy Navigation Function - Panasonic CZ-256ESMC3 Operating Instructions Manual

Energy navigation function

Indoor units will run in energy saving modes according to the amount of human activity detected by
ECONAVI sensors (sold separately).
When there is a lot of human activity
In cooling or drying mode
z
Operates at the set temperature.
In heating mode
z
The air conditioners run at a temperature lower than the set
temperature.
When there is not a lot of human activity
In cooling or drying mode
z
The air conditioners run at a temperature higher than the set
temperature.
In heating mode
z
Operates at the set temperature.
Do not use the ECONAVI feature in rooms where only disabled people or infants are present.
(It may cause damage to their condition or worsen their health)
If there is not much movement for a long time, the ECONAVI sensor may determine that the room is unoccupied and stop the air
Warning
conditioning unit.
Note
y You can turn on or off the ECONAVI feature on this unit.
y You will need a separate remote controller* with ECONAVI functionality in order to make advanced settings for the ECONAVI feature. Refer to
the operating instructions for the remote controller* with ECONAVI functionality for details on how to configure the feature.
y Even if the target temperature is changed by ECONAVI, the set temperature displayed on the unit will not change.
y Even if the mode is switched to fan due to the absence of people (standby mode), the mode displayed on the unit will not change.
y When running multiple indoor units, the energy reduction effect may be reduced depending on the conditions in the room.
* Multi-function wired remote controller (CZ-RTC5 or later)
When there are no people
When there is a continuous 20 minute period of no people
In cooling or drying mode
z
The temperature is set higher than when there are people in the
room.
In heating mode
z
The temperature is set lower than when there are people in the
room.
When there are no people for about an hour
y The units run according to the mode set for when there are no
people. The factory preset is for low energy use operation to
continue with the temperature suppressed. (Refer to the operating
instructions for the ECONAVI sensor for information on the
operation mode when there are no people.)
y If people are detected while operating in the Absent mode, the air
conditioners return to a mode appropriate to the level of activity.
11