Panasonic CZ-256ESMC3 Operating Instructions Manual page 45

6
Register setting cells.
Repeat the following (1) to (3) to register setting cells.
z
(1) Touch [New data].
The "Sttg" dialogue is displayed.
z
In the "Sttg" dialogue, set "Time", "ON/OFF",
z
"OpertnMode", "Temperatre", "Fan SPD", "Flap", "Prhbt",
and "EnerSavStg".
6-
1
(2) Change the settings.
Item
Time Set the time for the operation.
1) Touch [Time].
2)
Use
"minute".
ON/OFF Set whether to start or stop operation.
1) Touch [ON/OFF].
2) Select "ON" or "OFF".
OpertnMode Set the operating mode.
1) Touch [OpertnMode].
2)
Select the operating mode (
(automatic)).
Explanation
to set the "hour" and
(heating),
(drying), (cooling), (fan),
Item
Temperatre Set the temperature.
1)
2)
Fan SPD Set the strength of the fan.
1)
2)
Flap Set the direction of the airflow.
1)
2)
Prhbt Set whether to allow or prohibit use of the local
remote controller.
1)
2)
EnerSavStg Enable or disable energy saving operation.
1)
2)
Note
y You do not have to set all items, but "Time" must be set.
y You can register up to 50 setting cells per day for a single
indoor unit or single schedule group.
y When setting schedule groups, you can only set those
items that are common to the indoor units that make up the
group.
45
Setting a schedule
Explanation
Touch [Temperatre].
Set the temperature with and
(± in 1 °C steps)
Setting ranges
y In cooling or drying mode: Between 18 °C
and 30 °C
y In heating mode: Between 16 °C and
30 °C*
1
y Automatic: Between 17 °C and 27 °C
*1 The upper limit temperature for some
models is 26 °C.
Touch [Fan SPD].
Select the fan speed ( (high),
(low), (automatic)).
Touch [Flap].
Set the flap to the desired position (
(F2), (F3), (F4), (F5),
(Swing)).
y Heating, fan, and automatic (heating) can
be adjusted in 5 steps and cooling and dry
can be adjusted in 3 steps.
y You can set either or if the model
does not support airflow direction settings.
Touch [Prhbt].
Use to select from "Accept",
"Prhbt1", "Prhbt2", "Prhbt3", or "Prhbt4".
Accept: Allows operations with the remote
controller.
Prhbt1 to Prhbt4: Operations on the remote
controller are restricted. You can change the
restricted operations. (P.211)
Touch [EnerSavStg].
Select "Valid" or "Invl".
Continued on next page
.
(mid),
(F1),