Table of Contents
Advertisement
12
Select "Yes" for "O/D unit cyclic".
12
The "O/D unit cyclic" screen
A:
[Select all]/[Clear all] buttons
[Select all]
Select all outdoor units.
[Clear all]
Cancel selection of all
outdoor units.
B:
Set whether to enable outdoor unit cycling control
across the whole system or not.
Note
y If you select "Yes", make sure that you set
"No" for indoor unit cycling control settings.
C:
This switches between "Display" and
"Address" each time you touch it.
D:
The outdoor units with a check mark next to
them will be the subject of the changes to the
settings.
E:
The O/D unit cyclic is enabled for the selected
outdoor unit if you put a check mark here.
This is linked with the "O/D unit cyclic Valid"
("Setting" dialogue) (P.103) setting.
F:
The "Term setting" dialogue is displayed when
you touch this.
G:
The "Setting" dialogue is displayed when you touch this.
Control operation at regular intervals [O/D unit cyclic]
13
Touch [Register].
To cancel the settings, touch [Cancel].
z
Note
y Up to 5 control groups can be created.
y Control groups that have not been set will not be the object of
cyclic control.
B
A
D
E
F
104
13
C
G
- Quick Links:
- Troubleshooting
Hide quick links:
Advertisement
Table of Contents
