Snmp Traps; Configuring Snmp - ZyXEL Communications UAG5100 User Manual

46.11.2 SNMP Traps

The UAG will send traps to the SNMP manager when any one of the following events occurs.
Table 247 SNMP Traps
OBJECT LABEL
Cold Start
linkDown
linkUp
authenticationFailure

46.11.3 Configuring SNMP

To change your UAG's SNMP settings, click Configuration > System > SNMP tab. The screen
appears as shown. Use this screen to configure your SNMP settings, including from which zones
SNMP can be used to access the UAG. You can also specify from which IP addresses the access can
come.
Figure 369 Configuration > System > SNMP
Chapter 46 System
OBJECT ID DESCRIPTION
1.3.6.1.6.3.1.1.5.1 This trap is sent when the UAG is turned on or an agent
restarts.
1.3.6.1.6.3.1.1.5.3 This trap is sent when the Ethernet link is down.
1.3.6.1.6.3.1.1.5.4 This trap is sent when the Ethernet link is up.
1.3.6.1.6.3.1.1.5.5 This trap is sent when an SNMP request comes from non-
authenticated hosts.
UAG Series User's Guide
527