Acx2100 Ac Power Cord Specifications - Juniper ACX2000 Hardware Manual

NOTE: We recommend that you use a dedicated customer site circuit breaker rated for
2 A (100 VAC) or 1 A (240 VAC), or as required by local code. Doing so enables you to operate
the router in any configuration without upgrading the power infrastructure.
SEE ALSO
Connecting AC Power Cords to the ACX2100 Router | 104

ACX2100 AC Power Cord Specifications

Each AC power supply has a single AC appliance inlet that requires a dedicated AC power feed. Most sites
distribute power through a main conduit that leads to frame-mounted power distribution panels, one of
which can be located at the top of the rack that houses the router. An AC power cord connects each power
supply to the power distribution panel.
You can order detachable AC power cords, each approximately 8 ft (2.5 m) long that supply AC power to
the router. The C15 appliance coupler at the female end of the cord, as described by International
Electrotechnical Commission (IEC) standard 60320, inserts into the AC appliance inlet coupler. The plug
at the male end of the power cord fits into the power source receptacle that is standard for your geographic
location.
Table 20 on page 63 provides specifications on the AC power cord provided for each country or region.
Table 20: AC Power Cord Specifications
Country Model Number
Australia CBL-GP-C15-AU
China CBL-GP-C15-CH
Europe (except Italy, CBL-GP-C15-EU
Switzerland, and
United Kingdom)
Italy CBL-GP-C15-IT
Japan CBL-GP-C15-JP
Electrical Specification
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
250 VAC, 10 A, 50 Hz
125 VAC, 15 A, 50 Hz or 60
Hz
Plug Type Design Standard
SAA/3 AS/NZZS 3112-2000
PRC/3 GB2099, GB1002
VIIG CEE (7) VII
I/3G CEI 23–16
498GJ JIS 8303
63