Acx2000 Chassis Components; Front Panel Of An Acx2000 Router - Juniper ACX2000 Hardware Manual

ACX2000 Chassis Components

IN THIS SECTION

Front Panel of an ACX2000 Router | 47

Front Panel of an ACX2100 Router | 48
Uplink Ports on ACX2000 and ACX2100 Routers | 50
ACX2000 and ACX2100 Alarm Contact Port | 54
Clocking Ports on the ACX2000 and the ACX2100 Router | 56
LEDs on ACX2000 and ACX2100 Routers | 57
Front Panel of an ACX2000 Router
The front panel of an ACX2000 router consists of the following components (see
Chassis status LED labeled SYS
DC power terminals
Two USB ports for upgrading Junos OS
Management Ethernet port labeled MGMT
Console or auxiliary port labeled CONSOLE/AUX
Alarm contact port labeled ALARM—accepts a DE-15 alarm cable
External clocking input port labeled EXT REF CLK IN
External clocking ports supporting 1PPS and 10MHz input and output
Network ports and corresponding status LEDs:
Sixteen T1/E1 ports labeled 0/0/0 through 0/0/15
Six Gigabit Ethernet RJ-45 ports labeled 0/1/0 through 0/1/2 and 0/1/4 through 0/1/6
Two 65-W PoE Gigabit Ethernet ports labeled 0/1/3 POE and 0/1/7 POE that provide electrical
current to devices—such as IP phones, wireless access points, and security cameras—through network
cables. These ports comply with IEEE 802.3af (PoE) and IEEE 802.3at (PoE+).
Two Gigabit Ethernet (GE) ports labeled 0/2/0 and 0/2/1 that accept SFP transceivers
Two 10-Gigabit Ethernet (XE) ports labeled 0/3/0 and 0/3/1 that accept SFP+ transceivers
Figure 9 on page 48):
47