Maintaining Acx2000 And Acx2100 Components; Routine Maintenance Procedures For The Acx2000 And Acx2100 Router; Maintaining Cables That Connect To Acx2000 Or Acx2100 Network Ports - Juniper ACX2000 Hardware Manual

Maintaining ACX2000 and ACX2100 Components

IN THIS SECTION

Routine Maintenance Procedures for the ACX2000 and ACX2100 Router | 117

Maintaining Cables That Connect to ACX2000 or ACX2100 Network Ports | 117

Maintaining the ACX2000 and ACX2100 Uplink Ports | 118
Removing a Transceiver from the ACX2000 or ACX2100 | 119
Installing a Transceiver in the ACX2000 or ACX2100 | 121
Replacing an ACX2000 or ACX2100 Management Ethernet Cable | 122
Replacing an ACX2000 or ACX2100 Console or Auxiliary Cable | 123
Routine Maintenance Procedures for the ACX2000 and ACX2100 Router
Purpose
For optimum router performance, perform preventive maintenance procedures.
Action
Inspect the installation site for moisture, loose wires or cables, and excessive dust. Make sure that airflow
is unobstructed around the router and into the air intake vents.
Check the status-reporting devices on the font panel—system LED.
Maintaining Cables That Connect to ACX2000 or ACX2100 Network Ports
Purpose
For optimum router performance, verify the condition of the cables that connect to the network ports.
Action
On a regular basis:
Place excess cable out of the way. Do not allow fastened loops of cable to dangle from the connector,
because this stresses the cable at the fastening point. Putting fasteners on the loops helps to maintain
their shape.
117