Juniper ACX2000 Hardware Manual page 120

WARNING:
fiber-optic cables. Fiber-optic transceivers and fiber-optic cables connected to a
transceiver emit laser light that can damage your eyes.
4. Remove the cable connector from the transceiver.
5. Pull the ejector handle out from the transceiver to unlock the transceiver.
CAUTION:
it click. This action prevents damage to the transceiver.
Use needlenose pliers to pull the ejector handle out from the transceiver.
6. Grasp the transceiver ejector handle, and pull the transceiver approximately 0.5 in. (1.3 cm) out of the
router.
7. Using your fingers, grasp the body of the transceiver, and pull it the rest of the way out of the router.
Figure 28: Removing Transceivers
8. Place a rubber safety cap over the transceiver.
9. Place the removed transceiver on an antistatic mat or in an electrostatic bag.
Do not look directly into a fiber-optic transceiver or into the ends of
Make sure that you open the ejector handle completely until you hear
120