Removing A Transceiver From The Acx2000 Or Acx2100 - Juniper ACX2000 Hardware Manual

ACX2000 router:
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
ACX2100 router:
user@host> show chassis fpc pic-status
Slot 0 Online
PIC 0 Online
Slot 1 Online
PIC 0 Online
PIC 1 Online
PIC 2 Online
PIC 3 Online
SEE ALSO
ACX2000 and ACX2100 Routers Hardware and CLI Terminology Mapping | 20

Removing a Transceiver from the ACX2000 or ACX2100

Removing a transceiver does not interrupt router functioning, but the removed transceiver no longer
receives or transmits data.
To remove a transceiver (see
1. Have ready a replacement transceiver or a transceiver slot plug, an antistatic mat, and a rubber safety
cap for the transceiver.
2. Wrap and fasten one end of the ESD grounding strap around your bare wrist, and connect the other
end of the strap to an ESD point.
3. Label the cables connected to the transceiver so that you can reconnect them correctly later.
16x CHE1T1, RJ48
8x 1GE(LAN) RJ45
2x 1GE(LAN) SFP
2x 10GE(LAN) SFP+
16x CHE1T1, RJ48
4x 1GE(LAN) RJ45
4x 1GE(LAN) SFP, RJ45
2x 1GE(LAN) SFP
2x 10GE(LAN) SFP+
Figure 28 on page 120):
119