Turning On The Server - Avaya Aura System Platform Installing And Configuring

Server installation and connectivity
Next steps
Install the cable management arm if desired.

Turning on the server

After the server is installed in the rack, turn it on to make sure that it works. Once you determine
that it works, turn it off before you start any software installation procedure.
Important:
You must wait for the power-on LED to blink slowly (one flash per second) before pressing
the power button. If you press the power button while the power-on LED is blinking quickly
(three flashes per second), the server will not turn on.
1. Plug one end of the power cord into the back of the power supply and the other end
2. Once the power-on LED begins to blink slowly, press the power button on the front of
36 Installing and Configuring Avaya Aura
into a UPS or nonswitched outlet.
Approximately five seconds after the server is connected to power, one or more fans
might start running to provide cooling, and the power-on LED will blink quickly (three
flashes per second). Approximately three minutes after the server is connected to
power, the power-on LED will blink slowly (one flash per second), and one or more
fans might start running.
the server.
The power-on LED will stop blinking and stay lit. After you press the power button,
the server takes approximately five minutes to initialize.
Important:
Avaya recommends that users not change the default uEFI/BIOS settings.
™
System Platform April 2010