Avaya Aura System Platform Installing And Configuring page 51

2. To configure eth0 or eth1 or both, perform the following tasks:
3. Complete the Default gateway IP field.
4. Use the Tab key to highlight OK and press Enter to accept the configuration and
Installing and Configuring Avaya Aura
• Use the Tab key to highlight the Physical Devices field.
• Use the down arrow or the up arrow key to highlight eth0 or eth1 in the
Physical Devices field.
• Complete the Static IP field.
The server displays a default value for the Subnet mask field. You can modify
this field.
Note:
Avaya recommends that you use the default value of 192.11.13.6 for eth1.
Note:
Although you can enter default gateway for each interface, you should specify
only one default gateway. Specifying more than one default gateway may result
in an unusable internal networking configuration. Specifying one valid default
gateway is mandatory for the System Platform installation.
Important:
Be careful not to use the Tab key on other ethernet interfaces. Set eth0 to the
customer IP address and set eth1 to the services IP address. Do not configure
eth2 and eth3.
display the System Platform Console Domain Network Configuration screen.
™
System Platform
Installing System Platform software
April 2010 51