Preparing For Installation - Avaya Aura System Platform Installing And Configuring

Field
Secondary DNS
NTP Server 1
NTP Server 2
NTP Server 3
eth1
This is a physical Ethernet interface (NICs) on the server. You must configure these interfaces
for IP. The table shows the default settings for the Services port. Avaya recommends keeping
these default settings.
Field
Static IP
Subnet mask
Default gateway IP
Passwords
Default passwords are provided. You should change these default passwords.
Field
root
admin
cust
ldap

Preparing for installation

You can use a DVD or a USB flash drive for installing System Platform. After you decide your
preferred media for installation, you must set up the DVD or the USB flash drive for the
installation. You must also verify the ISO image after downloading from the PLDS site. The
flow of tasks for preparing yourself for the installation is as follows:
• Set up the media to install the software. Do one of the following depending on your
preferred media:
- Setting up a USB flash drive for System Platform installation
- Setting up a DVD for System Platform installation
Installing and Configuring Avaya Aura
Value/requirement
Value/requirement
192.11.13.6
255.255.255.252
Value/requirement
™
System Platform
Preparing for installation
Notes
Optional
Use of NTP server is optional.
However, Avaya
recommends its use.
Optional
Optional
Notes
Notes
on page 23.
on page 22.
April 2010 21