Circumferential Slot - Slot2 - Siemens SINUMERIK 840D sl Programming Manual

No. Param Param
mask internal
_AMODE
31
Note
The cycle is provided with new functions that are not on earlier software versions.
Consequently certain parameters in the input mask (
Multiple slots on one position pattern can be programmed using "MCALL" and calling the
desired position pattern, e.g. HOLES2.
18.1.21

Circumferential slot - SLOT2

Programming
SLOT2(REAL RTP, REAL RFP, REAL SDIS, REAL _DP, REAL _DPR, INT NUM,
REAL AFSL, REAL WID, REAL _CPA, REAL _CPO, REAL RAD, REAL STA1, REAL
INDA, REAL FFD, REAL FFP1, REAL _MID, INT CDIR, REAL _FAL, INT VARI,
REAL _MIDF, REAL FFP2, REAL SSF, REAL _FFCP, INT _UMODE, REAL _FS,
REAL _ZFS, INT _GMODE, INT _DMODE, INT _AMODE)
Parameters
No. Param Param
mask internal
1 RP RTP
2 Z0 RFP
3 SC SDIS
Z1 _DP
4
_DPR
5
6 N NUM
7 α1 AFSL
8 W WID
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Alternative mode
UNITS: Final depth Z1 (abs/inc)
0 = Compatibility
1 = Z1 (inc)
2 = Z1 (abs)
TENS: Reserved
HUNDREDS: Insertion depth for chamfering ZFS
0 = ZFS (abs)
1 = ZFS (inc)
Explanation
Retraction plane (abs)
Reference point of tool axis (abs)
Safety clearance (to be added to reference point, enter without sign)
Slot depth (abs)
Slot depth (inc) with respect to Z0 (enter without sign)
Number of slots
Opening angle of the slot
Slot width
Programming cycles externally
18.1 Technology cycles
, ) are no longer displayed.
NUM, RAD INDA
675