Switch-In The Electronic Gearbox (Egon, Egonsyn, Egonsyne) - Siemens SINUMERIK 840D sl Programming Manual

Note
The coupling factors are preset to zero when the EG axis grouping is defined.
Note
EGDEF
unaltered if, for systems, one or more leading axes affect the following axis via a curve table.
Example
Program code
EGDEF(C,B,1,Z,1,Y,1)
11.4.2

Switch-in the electronic gearbox (EGON, EGONSYN, EGONSYNE)

Function
There are 3 ways to switch-in an EG axis group.
Syntax
Variant 1:
The EG axis group is selectively switched-in without synchronization with:
EGON(FA,"block change mode",LA1,Z1,N1,LA2,Z2,N2,...,LA5,Z5,N5)
Variant 2:
The EG axis group is selectively activated with synchronization with:
EGONSYN(FA,"block change mode",SynPosFA,[,LAi,SynPosLAi,Zi,Ni])
Variant 3:
The EG axis group is selectively switched-in with synchronization and the approach mode
specified with:
EGONSYNE(FA,"block change mode",SynPosFA,approach
mode[,LAi,SynPosLAi,Zi,Ni])
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
triggers preprocessing stop. The gearbox definition with
Comment
; Definition of an EG axis group. Leading axes B, Z, Y
influence the following axis C via the setpoint.
Axis couplings
11.4 Electronic gear (EG)
should also be used
EGDEF
525