Deep-Hole Drilling - Cycle83 - Siemens SINUMERIK 840D sl Programming Manual

No. Param Param
mask internal
8 FR RFF
_GMODE
9
10 _DMODE
11 _AMODE
18.1.5

Deep-hole drilling - CYCLE83

Programming
CYCLE83(REAL RTP, REAL RFP, REAL SDIS, REAL DP, REAL DPR, REAL FDEP,
REAL FDPR, REAL _DAM, REAL DTB, REAL DTS, REAL FRF, INT VARI, INT
_AXN, REAL _MDEP, REAL _VRT, REAL _DTD, REAL _DIS1, INT _GMODE, INT
_DMODE, INT _AMODE)
Parameters
No. Param Param
mask internal
1 RP RTP
2 Z0 RFP
3 SC SDIS
4 Z1 DP
Z1 DPR
5
D FDEP
6
7 D FDPR
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Feedrate during retraction
Reserved
Display mode
UNITS: Machining plane G17/G18/G19
0 = Compatibility, the plane effective before cycle call remains active
1 = G17 (only active in the cycle)
2 = G18 (only active in the cycle)
3 = G19 (only active in the cycle)
Alternative mode (drilling)
UNITS: Drilling depth Z1 (abs/inc)
0 = Compatibility, from DP/DPR programming
1 = Incremental
2 = Absolute
TENS: Dwell time DT at final drilling depth in seconds/revolutions
0 = Compatibility, from DT sign (> 0 seconds or < 0 revolutions)
1 = In seconds
2 = In revolutions
Explanation
Retraction plane (abs)
Reference point (abs)
Safety clearance (to be added to reference point, enter without sign)
Final drilling depth (abs), see _AMODE
Final drilling depth (inc), see _AMODE
1st drilling depth (abs), see _AMODE
1st drilling depth (inc), see _AMODE
Programming cycles externally
18.1 Technology cycles
645