Siemens SINUMERIK 840D sl Programming Manual page 715

No. Param Param
mask internal
2 S_TOLM
3 ORI S_OTOL
toler-
ance
Orientation tolerance derived from of the contour tolerance multiplied by the factor from the cycle setting data SD55441
1)
to SD55443.
References:
Commissioning Manual, Base Software and Operator Software; SINUMERIK Operate (IM9), Section "Configuring the
High Speed Settings function (CYCLE832)"
Note
When CYCLE832 is deselected, parameter S_TOL must be transferred with zero.
Example:
The syntax
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
Machining type (technology)
UNITS:
0 = Deselection
1 = Finishing
2 = Semi-finishing
3 = Roughing
TENS:
0 = Compatibility or no orientation tolerance
1)
1 = Orientation tolerance in the 3rd parameter
To improve the readability of the cycle call, the "Machining mode" parameter can also be
entered in plain text. Plain texts are not language-dependent. The following entries are
permitted:
_FINISH
_SEMIFIN
_ROUGH
_ORI_FINISH
_ORI_SEMIFIN
_ORI_ROUGH
OFF
Note:
The terms are based on the G function group 59 (dynamic response mode for path
interpolation). With these plain texts, 3-axis machines and machines with multi-axis orientation
transformation (TRAORI) are clearly separated in the application.
Orientation tolerance or version identifier CYCLE832
Tolerance parameter for the orientation of the workpiece.
Is required when executing a high-speed machining program on machines with dynamic
orientation transformation (e.g. 5-axis machining).
Parameter S_OTOL must be programmed. This also applies for applications on 3-axis
machines for programs without orientation of the tool (S_OTOL = 1).
CYCLE832(0,0,1)
is also permitted for deselecting CYCLE832.
CYCLE832()
= Finishing
= Semi-finishing
= Roughing
= Finishing with input of an orientation tolerance
= Semi-finishing with input of an orientation tolerance
= Roughing with input of an orientation tolerance
= Deselection
Programming cycles externally
18.1 Technology cycles
715