Swiveling - Cycle800 - Siemens SINUMERIK 840D sl Programming Manual

Programming cycles externally
18.1 Technology cycles
18.1.38

Swiveling - CYCLE800

Programming
CYCLE800(INT _FR, STRING[32] _TC, INT _ST, INT _MODE, REAL _X0, REAL
_Y0, REAL _Z0, REAL _A, REAL _B, REAL _C, REAL _X1, REAL _Y1, REAL
_Z1, INT _DIR, REAL _FR_I, INT _DMODE)
Parameters
No. Param Param
mask internal
_FR
1
_TC
2
3 _ST
712
Explanation
Retraction mode:
0 = No retraction
1 = Retraction machine axis Z
2 = Retraction machine axis Z and then XY
3 = Reserved
4 = Maximum retraction in tool direction
5 = Incremental retraction in tool direction
Name of swivel data record:
"" "" (no name) if only one swivel data record exists
"0" Deselect swivel data record (delete the swivel frames)
Status transformations
UNITS:
0 = New, swivel level is deleted and recalculated using the current parameters
1 = Additive, swivel level is added to active swivel level
TENS: Replace tool tip yes/no (only active when IBN SWIVEL function is set up)
0 = Do not replace tool tip
1 = Replace tool tip (TRAORI)
HUNDREDS: Approach/align tool (function is shown in tool swivel input mask)
0 = Do not approach tool
1 = Approach tool (preferably radial mill)
2 = Align turning tool (when B axis kinematic is set up for milling in IBN swiveling)
3 = Align milling tool (when B axis kinematic is set up for milling in IBN swiveling)
9 = Reserved
THOUSANDS: Internal "Swiveling in JOG" parameter
TEN THOUSANDS: See direction parameter _DIR
0 = Swivel "yes"
1 = Swivel "no", "minus" direction
2 = Swivel "no", "plus" direction
HUNDRED THOUSANDS: See direction parameter _DIR
0 = Compatibility
1 = Direction selection "Minus" optimized
2 = Direction selection "Plus" optimized
3)
3)
4)
4)
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Job Planning