Circumferential Slot - Slot2 - Siemens SINUMERIK 808D ADVANCED Programming And Operating Manual

Programming example: Grooves
Four slots are milled.
The slots have the following dimensions: Length 3 0 mm, width 15 mm and depth 23 mm. The safety clearance is 1 mm, the
final machining allowance is 0.5 mm, the milling direction is G2, the maximum infeed in the depth is 6 mm.
The slot is to be machined completely. Infeed during finishing is to be performed directly to the pocket depth and the same
feedrate and speed are to be used.
See the following programming example for grooves:
N10 G17 G90 T1 D1 S600 M3
N20 G0 X20 Y50 Z5
N30 SLOT1(5, 0, 1, -23, , 4, 30, 15, 40, 45, 20, 45, 90,
100, 320, 6, 2, 0.5, 0, , 0, )
N40 M02
9.6.8

Circumferential slot - SLOT2

Programming
SLOT2 (RTP, RFP, SDIS, DP, DPR, NUM, AFSL, WID, CPA, CPO, RAD, STA1, INDA, FFD, FFP1, MID, CDIR, FAL, VARI,
MIDF, FFP2, SSF, FFCP)
192
; Specification of technology values
; Approach starting position
; Cycle call, VARI, MIDF, FFP2 and SSF
parameters omitted
; End of program
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA1, 01/2014