Identifying Subprograms With Preparation (Prepro) - Siemens SINUMERIK 840D sl Programming Manual

Example 4: Display response in the case of different DISPLON/DISPLOF combinations
①
The part program lines from program level 0 are displayed in the current block display.
②
The part program lines from program level 3 are displayed in the current block display.
③
The part program lines from program level 3 are displayed in the current block display.
④
The part program lines from program level 7/8 are displayed in the current block display.
1.24.2.7

Identifying subprograms with preparation (PREPRO)

Function
All files can be identified with the
power up.
Note
This type of program preparation depends on the relevant set machine data. Please follow
the manufacturer's instructions.
References:
Function Manual, Special Functions, Preprocessing (V2)
Syntax
PROC ... PREPRO
Meaning
PREPRO
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
: Keyword for identifying all files (of the NC programs stored in the cycle
directories) prepared during power up
keyword at the end of the
PREPRO
Flexible NC programming
1.24 Subprogram technique
operation line during
PROC
175