Circumferential Slot - Slot2 - Siemens SINUMERIK 808D User Manual

12.6.8

Circumferential slot - SLOT2

Programming
SLOT2 (RTP, RFP, SDIS, DP, DPR, NUM, AFSL, WID, CPA, CPO, RAD, STA1, INDA, FFD, FFP1, MID, CDIR, FAL, VARI,
MIDF, FFP2, SSF, FFCP)
Pa rameters
Pa rameter D a ta type
RTP REAL
RFP REAL
SDIS REAL
DP REAL
DPR REAL
NUM INT
AFSL REAL
WID REAL
CPA REAL
CPO REAL
RAD REAL
STA1 REAL
INDA REAL
FFD REAL
FFP1 REAL
MID REAL
CDIR INT
FAL REAL
VARI INT
MIDF REAL
FFP2 REAL
SSF REAL
FFCP REAL
N o te
The cycle requires a milling cutter with an "end tooth cutting across center" (DIN844).
216
D e scription
Retraction plane (absolute)
Reference plane (absolute)
Safety clearance (enter without sign)
Slot depth (absolute)
Slot depth relative to the reference plane (enter without sign)
Number of slots
Angle for the slot length (enter without sign)
Circumferential slot width (enter without sign)
Center point of circle (absolute), first axis of the plane
Center point of circle (absolute), second axis of the plane
Radius of the circle (enter without sign)
Starting angle
Incrementing angle
Feedrate for depth infeed
Feedrate for surface machining
Maximum infeed depth for one infeed (enter without sign)
Milling direction for machining the circumferential slot
Values: 2 (for G2), 3 (for G3)
Finishing allowance at the slot edge (enter without sign)
Machining type
Values: 0 = complete machining, 1 = roughing, 2 = finishing
Maximum infeed depth for finishing
Feedrate for finishing
Speed for finishing
Feedrate for intermediate positioning on a circular path, in mm/min
Programming and Operating Manual (Milling)
6FC5398-4DP10-0BA6, 09/2017