Cut-Off - Cycle92 - Siemens SINUMERIK 840D sl Programming Manual

No. Param Param
mask internal
18.1.35

Cut-off - CYCLE92

Programming
CYCLE92(REAL _SPD, REAL _SPL, REAL _DIAG1, REAL _DIAG2, REAL _RC,
REAL _SDIS, REAL _SV1, REAL _SV2, INT _SDAC, REAL _FF1, REAL _FF2,
REAL _SS2, REAL _DIAGM, INT _VARI, INT _DN, INT _DMODE, INT _AMODE)
Parameters
No. Param Param
mask internal
X0 _SPD
1
2 Y0 _SPL
3 X1 _DIAG1
4 X2 _DIAG2
5 R/FS _RC
SC _SDIS
6
S _SV1
7
V
8 SV _SV2
9 DIR _SDAC
10 F _FF1
11 FR _FF2
12 SR _SS2
13 XM _DIAGM
_VARI
14
Job Planning
Programming Manual, 03/2013, 6FC5398-2BP40-3BA1
Explanation
TEN MILLIONS: Single/multiple thread
0 = Compatibility mode (starting angle _NSP is evaluated)
1 = Single thread (with starting angle offset _NSP)
2 = Multiple thread
Explanation
Reference point (abs, always diameter)
Reference point (abs)
Depth for speed reduction, see _AMODE (UNITS)
Final depth, see _AMODE (TENS)
Rounding status or chamfer width, see _AMODE (THOUSANDS)
Safety clearance (to be added to reference point, enter without sign)
Constant spindle speed, see _AMODE (TEN THOUSANDS)
Constant cutting rate
Maximum speed at constant cutting speed
Direction of spindle rotation
3 = for M3
4 = for M4
Infeed as far as depth for speed reduction
Reduced infeed as far as final depth
Reduced speed as far as final depth
Depth to withdraw parts gripper (abs, always diameter)
Machining type
UNITS: Retraction
0 = Retraction to _SPD+_SDIS
1 = No retraction at the end
TENS: Parts gripper
0 = No, do not execute M command
1 = Yes, call from CUST_TECHCYC(101)- open drawer, CUST_TECHCYC(102)- close
drawer
Programming cycles externally
18.1 Technology cycles
705