ADC SG-1 User Manual page 97

June 30, 2006
[loopback]
Places a logical loopback on the bridge-route interface.
<loopback number>
Numeric value assigned to the bridge-route loopback.
[mtu]
Used to set the interface's Maximum Transmission Unit (MTU) (valid values are 1500 or 1544).
Example(s)
Host(config)# interface atm 2 \ 1 \ 1 type bridge-route point-to-point ip
192.168.10.1 255.255.255.0 mtu 1544
Added item
Host(config)#
Using the pppoa enable command
Host(config)# pppoa enable interface
This command enables PPPoA negotiation for a specific interface within the system.
Usage
pppoa enable interface <slot number>\<port number\[sub-interface number]>
Before enabling PPPoA, you must configure the correct port and the ATM interface.
Parameter(s)
<slot>
<port number>
<sub-interface number>
Example(s)
Host(config)# pppoa enable interface 0 \ 1
SG1-UM-8500-03
Table 7-5. pppoa enable interface parameters
Parameter
Slot number.
Physical port number.
Sub-interface number.
Chapter 7: Second Level Commands
Description Legal values/range
1 - 2
1 - 2
1- 2000
7-17