Timeouts Commands - ADC SG-1 User Manual

June 30, 2006
T C
IMEOUTS OMMANDS
Timeouts are a used to stop activities if the SG-1 recognizes a problem with data transfer. session-Timeout
command
Setting the Session-Timeout
The session timeout is used to disconnect a user after a specified number of seconds.
Usage
session-timeout <number>
Parameter
<number>
It is the seconds number, session timeout in seconds 0 - 4250000 (0 = unlimited).
Example
To set the session timeout to 64800 seconds:
Host(config)# session-timeout 64800 <cr>
Setting the Idle-Timeout
The idle timeout is used to disconnect a connection without any traffic from the user to the network (upstream). The
user will be disconnected if the SG-1 doesn't detect any data traffic after the specified number of seconds.
idle-timeout command
Usage
idle-timeout <number>
Parameter
<number>
It is the seconds number, idle timeout in seconds 0 - 4250000 (0 = unlimited).
Example
To set the idle timeout of 1800 seconds:
Host(config)# idle-timeout 1800 <cr>
SG1-UM-8500-03
Chapter 7: Second Level Commands
7-33