June 30, 2006
Installing Blank Faceplates
Use the blank faceplate identified in the
Install blank faceplates in the SG-1 chassis to cover unused slots. Unused slots must be covered
IMPORTANT
to prevent personnel contact with back panel connectors under power and to maintain proper
!
airflow within the chassis.
Step
1
Slide the blank faceplate into the empty slot. Ensure the retaining latches are lifted.
2
Push the blank faceplate in until the retaining latches touch the SG-1 chassis.
3
Gently close the retaining latches until they snap into place.
4
Tighten the captive screw on the top and bottom retaining latches.
S
C
ERIAL
ABLE
SG1-UM-8500-03
"Blank Faceplate Requirement" on page
Action
Chapter 2: Installation
1-6.
2-5