Table of Contents
Advertisement
June 30, 2006
Example(s)
Host(config)# native-ip def-service-auth werbcvxsaq
Using the native-ip enable command
Host(config)# native-ip enable interface
This command enables native ip service on a specific interface.
It enables the native IP for a specific VLAN or interface.
Phase 1 should include Ethernet interface and VLAN-Id only.
Phase 2 should include interface atm.
Usage
native-ip enable interface [<Ethernet<slot\port> | VLAN <slot\port\identifier>
ATM <slot\port\sub-interface> | tunne <tunnel interface id> | l2transport <destina-
tion> <vc-id>
Parameter(s)
<slot\port>
This is the Ethernet slot number (valid number range is 0 to 2) and Ethernet port number (1 or 2).
<slot\port\identifier>
This is the Ethernet slot number (valid numbers 0 to 2), Ethernet port number (1 or 2), and VLAN identifier (1 to ?).
<slot\port\sub-interface>
This is the Ethernet slot number (valid number range is 0 to 2), Ethernet port number (1 or 2), and VLAN identifier
(sub-interface valid number 1 to 4095).
<tunnel interface id>
This is the tunnel interface identifier. Valid number range is 1 to 300.
<destination>
This specifies the LDP IP address of the remote PE. It must be a valid IP address.
<vc-id>
This assigns a VC ID to the virtual circuit between the system and the remote PE.
SG1-UM-8500-03
Chapter 7: Second Level Commands
|
7-35
Advertisement
Table of Contents
