ADC SG-1 User Manual page 136

Chapter 7: Second Level Commands
Usage
no ip default-gateway
Example(s)
Host(config)# no ip default-gateway
When assigning a default-gateway that is not in the subnet of the primary or secondary Ethernet interfaces, the
system provides a warning.
Host(config)# ip default-gateway 194.90.2.1
Operation Warning:
The default gateway is out of subnet
Using the router command
Host(config)# router
This command defines the system default routing process. In cases where advertisement should take place and
there is no other higher priority definition, the system uses this definition. The routing modes include Routing
Information Protocol Version 2 (RIPv2) and Open Shortest Path First protocol (OSPF).
Usage
router <ripv2 | ospf>
Example(s)
Host(config)# router ripv2
Host(config)# router ospf
Using the router id command
Host(config)# router id
This command defines the system router id.
Usage
router id < router ip>
Parameter(s)
<router ip>
OSPF router ID in IP address format.
7-56
June 30, 2006
SG1-UM-8500-03