Loopback Commands - ADC SG-1 User Manual

Chapter 7: Second Level Commands June 30, 2006
L C
OOPBACK OMMANDS
Configuring interface loopback
Host(config)# interface loopback
This command enables the administrator to either add or change the loopback interface.
Note: The loopback interface can be part of the IP route lines/commands.
Usage
interface loopback <interface number> <IP address> <mask>
Parameter(s)
<interface number>
This is the interface number of the loopback; the valid range is 1 to 200.
<IP address>
This is the loopback IP address; it must be a valid IP address.
<mask>
This is the loopback mask address.
7-8 SG1-UM-8500-03