Table of Contents
Advertisement
June 30, 2006
Displaying VRRP attributes
Host> show vrrp interface
Use this command to display the configured Virtual Router Redundancy Protocol (VRRP) status on the specified
interfaces.
Usage
show vrrp interface (<ethernet>|<vlan>) <slot number> <port number> <number>
Parameter(s)
(<ethernet>|<vlan>)
The interface will be either an Ethernet or VLAN interface.
<slot number>
Slot number; valid values are 0 to 3.
<port number>
Defines the port; valid values are 1 or 2.
<number>
Defines the Virtual Router ID number (VRID); valid values are 1 to 15.
Example(s)
For the master:
Host> show vrrp interface Ethernet 0\1
Ethernet 0\1 - Group 1
State is Master
Virtual IP address is 192.168.1.1
Master router is 192.168.1.2 (local)
Virtual MAC address is 00-00-5E-00-01-01
Advertisement interval is 1 seconds
Priority 254
Preemption mode: off
Host>
SG1-UM-8500-03
Chapter 6: First-Level Commands
6-21
Advertisement
Table of Contents
