Table of Contents
Advertisement
Appendix A: SG-1 Vendor-Specific Attributes
service:auth-source
This sub-attribute defines the source name to be used when the POPmaestro authorizes or authenticates a service
with the RADIUS. The POPmaestro performs a RADIUS access request when a service is activated. The
service:auth-source attribute defines the source name to be used as the user-name in this request. The
authentication source can have one of the following values: user, service, or CLI. When the value is not service, the
POPmaestro includes the requested service name in the RADIUS access request message (see user:service-name
attribute). The authentication source default value is service. The attribute may be included only once in access-
accept message. When appearing more than once, the system will consider the last attribute appearance.
General:
Format:
adc-avpair = "service:auth-source=<service | user | CLI>",
Example:
adc-avpair = "service:auth-source=CLI",
service:data-quota
This sub-attribute defines the service session data quota measured in bytes. The POPmaestro monitors the session
to track the data quota usage. When a service runs out of quota (session quota termination event occurs), the
system activates the next-service-name if defined (see next-service-name definition). This is true in case that the
service authentication base is set to be service. Otherwise the POPmaestro activates reauthorization according to
the configured service:auth-base value (see service:auth-base definition). A service:data-quota attribute with a zero
value indicates the POPmaestro that the connected session has no data credit left and should be logged off. The
POPmaestro then disconnects the session. When a session is disconnected or when the service is exchanged, the
POPmaestro includes the service:data-quota attribute in the accounting message with the remainder data credit.
The attribute may be included only once in access-accept message. When appearing more than once the system
will consider the last attribute appearance.
General:
Format:
adc-avpair = "service:data-quota=<data quota in bytes>",
A-20
Operation Mode:
Vendor-type:
Vendor-length =
Operation Mode:
Access-Accept message
Access-Request message
Service-Accept message
Service-Request message
Accounting-Request messages
Vendor-type:
54
Vendor-length =
2 + name length + (1 - 10)
Access-Accept message
Service-Accept message
53
2 + name length + (3 - 7)
June 30, 2006
SG1-UM-8500-03
Advertisement
Table of Contents
