ADC SG-1 User Manual page 138

Chapter 7: Second Level Commands
Example(s)
Host(config)# ip
Host(config)# ip
Host(config)# ip
Using the no ip ospf interface command
Host(config)# no ip ospf interface
This command disables OSPF on an interface.
Usage
no ip ospf interface <Ethernet | VLAN | ATM> <slot number>\<port number>
[\<sub-interface>]
For parameters and examples, refer to
Using the ip ospf interface hello-interval command
Host(config)# ip ospf interface ... hello-interval
This command specifies the interval time in seconds between hello packets.
Usage
ip ospf interface <Ethernet | VLAN | ATM> <slot number>\<port number>
[\<sub-interface>] hello-interval <seconds>
Parameter(s)
<seconds>
The time interval between hello packets.
For additional parameters, refer to
Example(s)
Host(config)# ip ospf interface Ethernet 1 \ 2 hello-interval 22
Host(config)# ip ospf interface ATM 2 \ 1 \ 44 hello-interval 32
Host(config)# ip ospf interface VLAN 1 \ 2 \ 33 hello-interval 23
Using the no ip ospf interface hello-interval command
Host(config)# no ip ospf interface ... hello-interval
The command sets the interval time between hello packets to its default value.
Usage
no ip ospf interface <Ethernet | VLAN | ATM> <slot number>\<port number>
[\<sub-interface>] hello-interval
For parameters and examples, refer to
7-58
ospf interface Ethernet 1 \ 2 area 12.3.5.6
ospf interface ATM 2 \ 1 \ 32 area 12.5.45.8
ospf interface VLAN 1 \ 2 \ 33 area 44.55.2.15
"Using the ip ospf interface command" on page
"Using the ip igmp proxy command" on page
"Using the ip ospf interface hello-interval
June 30, 2006
7-57.
7-51.
command".
SG1-UM-8500-03