Routing Command - ADC SG-1 User Manual

Chapter 7: Second Level Commands
R C
OUTING OMMAND
Using the ip forward command
Host(config)# ip forward
This command enables IP forwarding between the Ethernet interfaces. The system's default setting does not use IP
forwarding.
Usage
ip forward
Host(config)# no ip forward
This command disables IP forwarding between the Ethernet interfaces.
Usage
no ip forward
Using the IP route command
Host(config)# ip route
The ip route command is used for establishing static routes. A static route is appropriate when the SG-1 is not
dynamically building the routes to the destinations.
Usage
ip route <[nip <destination prefix> <destination prefix mask> <forwarding router's>]
| [<destination prefix> <destination prefix mask> <[<forwarding router's>] |
[<<Ethernet interface | ATM interface> <slot number>\<port number>\[<sub-interface
number]>>| <loopback interface>]>]>
Parameter(s)
Parameter
<destination prefix>
<destination prefix mask>
<forwarding router's>
<Ethernet interface | ATM
interface>
<slot number>
<port number>
<sub-interface number>
7-52
Table 7-14. ip route command parameters
Description
Destination IP or Network
Network mask
Next-hop IP address
Interface type
PMC slot number
SONET physical port number
Sub interface number
June 30, 2006
Values
Valid IP or Network
Valid Mask (Except to 0.0.0.0)
Valid IP address
Interface type: Ethernet or
ATM
0 - 1
1 - 2
1- 2000
SG1-UM-8500-03