Ethernet Commands - ADC SG-1 User Manual

Appendix B: Redirection Server
Example:
RDSHost>
RDSHost> show system
Up-time: 0 Hours, 38 Minutes, 23 Seconds
CPU usage: 50 %
Average Http hits per minute:8681
Accumulated Http hits on port 80:19993456
Accumulated Http hits on EDS port:39986912
RDSHost>
E C
THERNET OMMANDS
Using interface Ethernet command
• The Ethernet command is used for configuring the RDS IP address.
• It is located at the "configure terminal" menu.
• The change is affecting immediately.
Usage
interface Ethernet 1 <RDS IP address> <RDS mask> [mode <Ethernet mode>]
Parameter(s)
<RDS IP address>
This is the IP address of the Ethernet interface of the Redirection Server.
<RDS mask>
This is the mask of the Ethernet interface of the Redirection Server.
<Ethernet mode>
This is the Ethernet mode and it is one of the following: Auto, 10H, 10F, 100H, 100F, 1000H(negotiate), 1000F
(negotiate). The default mode is Auto.
Example:
RDSHost>
RDSHost> config termin <cr>
RDSHost(config)> interface Ethernet 1 192.168.2.5 255.255.255.0 <cr>
RDSHost(config)>
B-10
June 30, 2006
SG1-UM-8500-03