Table of Contents
Advertisement
Chapter 4: Accessing the Command Line Interface
Step
3
Press ENTER to initiate the terminal session.
4
Enter your user name at the Username: prompt.
5
Enter your password at the Password: prompt.
The system will display the Host> prompt:
Welcome to SG-1 System
Username: technician
Password: *****
Login Successful
Host>
S
IP A
ETTING THE
DDRESS
Host> configure terminal
Host(config)# interface ethernet
Set the management card IP address, subnet mask, and default gateway (if a gateway exists) to enable
communication with external networks and to enable access to the SG-1 CLI for Telnet sessions.
To set a new IP address and subnet mask for the SCC, do the following.
Step
1
From the Host(config)# prompt, enter the interface command in the following format:
interface ethernet <slot number>\<port number> <ipaddr> <netmask> mode
<ethernet mode> [mtu <1500|1544>]
2
From the Host(config)# prompt, enter the ip default-gateway command in the following format:
ip default-gateway <ipaddr>
3
For this change to become permanent, the user must perform a write memory command from the
Host> first level prompt to save this change to NVRAM (when the save command is issued, it saves all
systems parameters):
write memory
4-2
Action
Action
June 30, 2006
SG1-UM-8500-03
Advertisement
Table of Contents
