Route Group - ADC SG-1 User Manual

Appendix A: SG-1 Vendor-Specific Attributes

ROUTE GROUP

route:remote-filter-redirect-gw
This vendor specific sub-attribute defines the remote redirection gateway for redirecting the packets that did not
pass the defined filters. It also works dynamically and allows changing the user-redirected gateway on the fly. Upon
receipt of this sub-attribute the system tunnels the user data to the remote Redirection Gateway using the IP in IP
tunnel protocol. When a redundant RDS is configured the system uses it, if the first prioritized RDS is not
responding.
General:
Format:
adc-avpair = "route:remote-filter-redirect-gw=<gateway IP address>[,<redundant
gateway IP address]>",
Example:
adc-avpair = "route:remote-filter-redirect-gw=192.168.1.23,192.168.1.24",
route:next-hop
This sub-attribute defines the next-hop router to be used for the user connection upstream traffic. It may be activated
dynamically, enabling the change of the next-hop router of a connected user on the fly.
General:
Format:
adc-avpair = "route:next-hop=<Next-hopIP address>",
Example:
adc-avpair = "route:next-hop=192.168.1.23",
route:nip-pipe-next-hop
The route:nip-pipe-next-hop attribute defines the next-hop router to be used for the traffic destined to a native IP
user. The system when receiving this attribute directs the traffic through the native IP PIP to the defined next-hop.
The attribute may be sent in Access-Accept message and operated during the session lifetime and it overwrites the
current native IP pipe next-hop of the user session. It may be included once in access accept messages, and the
A-26
Operation Mode:
Vendor-type:
Vendor-length =
Operation Mode: Access-Accept message
Service-Accept message
Vendor-type: 71
Vendor-length = 2 + name length + (7-15)
Access-Accept message
Service-Accept message
70
2 + name length + (7-15)
June 30, 2006
SG1-UM-8500-03