ADC SG-1 User Manual page 144

Chapter 7: Second Level Commands
Parameter(s)
<slot number>
This is the SCC slot number; valid number range is 0 to 2.
<port number>
This is the SCC port number; valid values are 1 or 2.
<sub-interface>
This is the SCC for ATM sub-interface number; valid number range is 1 to 4095.
Example(s)
Host(config)# no mpls ip Ethernet 0\1
Using the mpls l2transport interface command
Host(config)# mpls l2transport interface
This command defines an MPLS l2vpn interface based on Martini. In order to change the mpls interface parameters,
the command should be deleted using the no mpls 12transport interface command and then reconfigured. The
maximum number of mpls l2transport interfaces in the system is 2,000.
Usage
mpls l2transport interface <destination> <vc-id> [<type <<ethernet>
<VLAN-ID>>> <IP address> <mask>]
Parameter(s)
<destination>
This specifies the LDP IP address of the remote PE; it should be a valid IP address.
<vc-id>
This assigns a VC ID to the virtual circuit between the system and the remote PE.
[<type>
This is the terminated interface type L2 encapsulation.
VLAN-ID
This the VLAN identifier.
<IP address>
This is the interface IP address.
<mask>
This is the interface IP mask.
7-64
June 30, 2006
| <VLAN
SG1-UM-8500-03