Table of Contents
Advertisement
Appendix A: SG-1 Vendor-Specific Attributes
PROTOCOL GROUP
protocol:type sub-attribute
There is a need in Access Request messages to receive a hint of the protocol negotiated with the peer. The
protocol:type sub-attribute fulfills this need and enables the operator to manage the connections. The system sends
this sub-attribute to the RADIUS when detecting a connection-negotiating multilink.
Note:
In multi-link calls, this sub-attribute is sent per each link.
General:
Format:
adc-avpair = "protocol:type=[mlp]",
Example:
adc-avpair = "protocol:type=mlp",
SERVICE GROUP
service:service-timeout
This sub-attribute defines the service session timeout measured in seconds. When a service session timeout event
occurs the system activates the next-service-name as defined in the next-service-name sub-attribute (section 2.3.2).
A service:service-timeout attribute with a zero value indicates the POPmaestro that the connected session should
be logged off. The attribute may be included only once in access-accept message. When appearing more than once
the system will consider the last attribute appearance.
General:
Format:
adc-avpair = "service:service-timeout=<timeout in seconds>",
Example:
adc-avpair = "service:service-timeout=500",
A-18
Operation Mode:
Access-Request message
Vendor-type:
40
Vendor-length =
2 + name length + 3
Operation Mode:
Access-Accept message
Service-Accept message
Vendor-type:
50
Vendor-length =
2 + name length + (1 - 10)
June 30, 2006
SG1-UM-8500-03
Advertisement
Table of Contents
