Radius Commands - ADC SG-1 User Manual

Chapter 7: Second Level Commands
[OAM]
Operation And Management mode
• on - Enable OAM mode
• off - Disable OAM mode
• on-cc - Enable OAM mode with continuity check
Example(s)
Host(config)# atm pvc range 2 34 38 1 \ 2 \ 65 name arttt oam on ubr 120
RADIUS C
OMMANDS
Configuring the RADIUS server in the SG-1 configuration
Host(config)# radius-server
Each RADIUS server should be configured in the system. The radius-server command is used to configure the
RADIUS server settings.
Usage
radius-server <host | key>
Parameter(s)
There are two options for the first command-line argument:
• host–to configure the RADIUS server host parameters (see
• key–to define an alphanumeric string, which serves as a password for communicating with the
RADIUS server
Configuring the RADIUS server host
Host(config)# radius-server host
The host parameters include the IP address of the RADIUS server, the authentication port, the accounting port, and
the type of RADIUS server. The default authentication port is 1645, and the default accounting port is 1646. The
RADIUS server can be defined as one of three types.
• Merit
• Infovia
• Standard (default)
Usage
To set the host parameters of the RADIUS server:
radius-server host <IP address> auth-port <port address> acct-port <port number>
<m,i, or s> priority <radius priority><cr>
To set the RADIUS server key:
radius-server key <alphanumeric string> <cr>
7-22
"Configuring the RADIUS server host"
June 30, 2006
below)
SG1-UM-8500-03