Atm Commands - ADC SG-1 User Manual

Chapter 7: Second Level Commands
Example 1:
Host(config)# authentication web-auth-method CHAP <cr>
Host(config)# end <cr>
Host # write terminal.
authentication web-auth-method CHAP
...
The "no" command set the system web authentication mode to PAP.
Host(config)# no authentication web-auth-method
Example 2:
Host(config)# no authentication web-auth-method <cr>
Host(config)# end <cr>
Host # write terminal
...
ATM C
OMMANDS
This section describes the procedure for configuring an ATM PVC (Permanent Virtual Circuit). The following
requirements must be met before a circuit can be created.
• The SONET/SDH port must be configured.
• The interface must be configured as a working port.
• The sub-interface must be type PPP.
Using the port sonet command
Host(config)# port sonet
Use this command to configure the ATM card port (it has two ports) to reflect whether the physical interface is
SONET or SDH.
Note: Setting the interface type for one port will force the other port to the same type. This occurs because
the second port is used for implementing Automatic Protection Switching (APS), where the redundant port
must have the same interface type as the primary port.
7-14
June 30, 2006
SG1-UM-8500-03