ADC Release 3.1 User Manual page 436

1152700 Issue 1 February 2001 Section 2 Operation and Maintenance
DLP-792
Page 4 of 4
SELECTION
Interface Name
ATM VPI
ATM VCI
Operational State
Buffer Maximum Size
Cell Arrival Jitter
Tolerance
CBR Clock Mode
Page 2-416
© 2000, ADC Telecommunications, Inc.
Table 792-2. T3 CES Interface Configuration Options
DEFAULT OPTIONS
User Defined
<user 0-8
defined>
<user 0-10
defined>
Up Up
Down
Unknown
1600 1500 to 2000
800 750 to 1000
Adaptive Adaptive
Synchronous
SRTS
DEFINITIONS
Can be used to assign a name to the port or use
the system default.
This is a read only to show the available bits
configured for this port during connection
creation.
This is a read only to show the available bits
configured for this port during connection
creation.
Display only. State of the interface port is Up
and available for service, Down due to a
problem, or Unknown due to communication
error.
Maximum size measured in microseconds and
selectable in 10 microsecond increments.
Maximum size measured in microseconds and
selectable in 10 microsecond increments.
Sets the Constant Bit Rate clock to adapt to the
incoming bit stream, look for a constant
synchronous bit stream, or Synchronous Residual
Time Stamp used for recovering clock signals in
a packet system (ATM).