ADC Release 3.1 User Manual page 275

Page 4 of 5
Table 755-1. T1 Multi 1 Configuration Options, continued
SELECTION DEFAULT
Loopback Config None
Circuit Identifier <blank>
Table 755-2. ATM Interface Configuration Options for CRS Mode
SELECTION
Interface Name
Loopback Location Code
Recording Interface ID
Provisioned Endpoints
Interface Type
CAC Formula
Policing
Cell Scrambling
Over Subscription Rate
Max Active VPI Bits
Max Active VCI Bits
Max number of VPCs
Max number of VCCs
1152700 Issue 1 February 2001 Section 2 Operation and Maintenance
OPTIONS
None
Facility Payload
Terminal
Facility Line
Up to 20 alphanumeric
characters.
DEFAULT OPTIONS
<default> Alphanumeric
All 1s Alphanumeric
All 0s Numeric
UNI UNI
NNI
PCR PCR Based
SCR Based
Off On or Off
Off On or Off
<blank>
0 0 to 8
0 0 to 12
256 0 to 256
0 0-8192
DEFINITIONS
No loopback activated on this card.
Loops the payload after line data is
extracted.
Sends cells to the cellbus and back to the
ring. No changes are made to the payload.
Loops the incoming signal back to CPE,
generates AIS to the cellbus.
User defined. Usually describes the traffic,
customer, and/or channel number.
DEFINITIONS
User defined, up to 20 alpha numeric
characters.
Used to loopback the incoming signal and
transmit it back to the customer equipment.
The code is limited to 16 numeric
characters.
Identifies the site card and port location for
customer billing capabilities, (allows
assignment of a customer ID for each port.)
The code is limited to 15 numeric
characters.
Displays how many VPC or VCC endpoints
are configured by administrator on this card.
Specifies interface type as User to Network
Interface or Network to Network Interface.
Specifies Peak Cell Rate or Sustained Cell
Rate for Connection Admission Control.
User sets whether traffic will be policed for
Quality Of Service (QOS).
User sets whether traffic will be scrambled.
User sets depending on traffic contract.
Sets the maximum number of bits that may
be utilized from this port.
Sets the maximum number of bits that may
be utilized from this port.
Sets the maximum number of VPCs that
may be utilized from this port.
Sets the maximum number of VCCs that
may be utilized from this port.
© 2000, ADC Telecommunications, Inc.
DLP-755
Page 2-255