ADC Release 3.1 User Manual page 414

1152700 Issue 1 February 2001 Operation and Maintenance
DLP-790
Page 3 of 14
configured. The quantity of VCIs selected must match the Root VCI quantity or an error
message will appear asking the user to select the same quantity of VCIs selected at the root
endpoint.
13. Click on the Update Leaf button to configure the leaf endpoint. The Leaf interface in the
first box will now have the asterisks before the definition string showing it is already
configured. It should now be observed in the Configured Leaf Interface box. If a leaf was
misconfigured, highlight it in the Configured Leaf Interface box and click on Reset Leaf to
remove it and start over, otherwise, select the next leaf interface to configure. When
selecting the VCIs for the second and consecutive leaf endpoints, the VCI numbers must be
identical (ex. al leaves use VCI numbers 32 through 36 on a multi-point connection).
14. Once all the Leaf interfaces are configured, select the Next button to continue
Note: If the user tries to select the Next>>button before configuring all the leaf
interfaces, an error message appears.
15. The next window appears and allows the user to create a VCI "translation" from the Root to
the Leaf Endpoint. Refer to
arrow and then the Leaf VCI below it.
16. Select the >> button to map the VCIs and verify they are moved to the Selected Translation
box to the right. The user may opt not to mix the VCI translation by just selecting the >>
button multiple times to move each VCI to the translation box for a one to one match up. If
the VCIs desired are not displayed, the user may use the <<Previous button at the bottom
of the window to return to the previous configuration screen to reallocate the VCI numbers
being utilized.
17. Once all VCIs are mapped in the Selected Translation box, use the left mouse button to
select the Next>> button at the bottom of the window.
18. The next screen appears allowing the user to specify the usage information (NDC) and
service provider information for each VCI. Refer to
being configured by left mouse clicking on the down arrow and selecting a VCI from the
list.
19. Select the Segment Endpoint and Ingress NDC boxes if desired. Refer to
definitions of each option for Service Provider and network data collection information.
20. Select a Leaf Interface from the list provided at the lower half of the window. Select the
Root VCI being configured by left mouse clicking on the down arrow and selecting a VCI
from the list.
21. Select the configuration options as needed for the VCI using
Configure each leaf interface and each VCI number. Once completed, select the Next>>
button at the bottom of the window to continue to the next configuration window.
Page 2-394
© 2000, ADC Telecommunications, Inc.
Figure 790-5. Select the Root VCI number using the drop down
Figure 790-6. Select the Root VCI
Table 790-1
Table 790-1 as a reference.
for