ADC Release 3.1 User Manual page 387

FR-ATM VC CONNECTIONS
11. The bottom section of the FR-ATM window show in
parameters for the ATM half of the connection. The network element and interface
identification are displayed.
12. If the connection is to be configured as a segment endpoint, select the Segment Endpoint
box using the left mouse button for both the originating and destination ends. This option
will enable OAM cell loopback from this point to the originating end for performance
monitoring capabilities.
13. Just below the Segment Endpoint box are the Ingress and Egress NDC selections. These
will enable network data collection for the inbound and/or outbound traffic.
14. Next, under the heading VPI / NE / Rate (Kbps) and VCI / NE / Rate (Kbps), select an
available VPI and VCI number to be assigned for the endpoint. VPIs and VCIs with an NE
and Rate displayed are already in use.
15. To the right, the Service Provider Profile is displayed. Fill in the text boxes for each of the
following parameters:
Remote Interface Identifier - a fifteen-digit decimal number identifying the far end
interface (UNI or B-ICI).
Remote Connection Identifier - a four-digit VPI or five digit VCI decimal number
identifying the VCI and/or VPI at the remote interface.
Study Indication - select using the left mouse button. This indicates the usage
information is to be generated for study purposes.
16. When all of the parameters are filled in for both the originating FR endpoint and the
destination ATM VC endpoint, select the Next button at the bottom of the window to
continue.
17. The screen shown in
connection type selected from the previous screens are displayed. The window is divided
again showing the originating and destination NEs, and the Network Interface/Interface
Type and this time displays the DLCI or VCI at the end of the string. If DE Bit Tagging
was selected from the previous screen under the PVC Endpoint Parameters, the Service
Class Type will be NRT-VBR3. If not selected the class will be NRT-VBR2. This is not a
selectable field for the FR end of the connection. The ATM VC endpoint is configurable for
either VBR2 or VBR3.
18. Under the Ingress Traffic Contract heading is listed "NEW" and any existing traffic
contracts. Select from an existing traffic contract if available at both ends of the connection
or select NEW to create a new contract. If an existing contract is selected, click on the
Apply button to finish configuring the connection, otherwise go to step 19. The system
should respond with "Connection Configuration Successful".
1152700 Issue 1 February 2001 Operation and Maintenance
Figure 786-6 appears. Again the connection name assigned and the
DLP-786
Page 4 of 10
Figure 786-5 displays all the
Page 2-367
© 2000, ADC Telecommunications, Inc.